← Brewology.com

Vita Store › Apps › VitaBrightEX LUT Editor

VitaBrightEX LUT Editor changelog

v4.2 · Aug 18, 2026

No notes for this release.

v1.3 · Aug 18, 2026

VitaBrightEX v1.3 + LUT Editor v4.2

Critical fixes in this release

OLED: presets no longer destroy screen colours

The previous OLED screen filter applied CCT/gamma/contrast math directly
to the panel's 21-byte LUT rows. Those bytes are panel hardware control
registers — not linear RGB pixel values. Applying a colour matrix to them
produced wrong results and made every single preset look worse than the
default. This is now fully fixed.

The OLED LUT is left completely untouched by the filter system. Your
screen colour is set by the calibrated per-panel LUT file
(vitabright_lut_p5.txt etc.) loaded at boot — which already has the
correct white-point for your specific panel. Factory reset restores
this clean state instantly.

Tab switching now works reliably

The app was using sceCtrlPeekBufferPositiveExt2 which remaps the
physical L/R shoulder buttons to different bit positions (L1/R1 DS4
style) that the code wasn't reading. Fixed: uses plain
sceCtrlPeekBufferPositive so the physical L/R buttons correctly
switch tabs.

What each part now does

Plugin v1.3

  • OLED colour is controlled by the per-panel LUT file only
  • Filter math (CCT/gamma/contrast) is NOT applied to OLED — it was the wrong architecture and destroyed calibration
  • Hardware invert (sceDisplaySetInvertColorsForDriver) still works
  • LCD filter (IFTU CSC matrix) unchanged — works correctly

App v4.2 on Vita 1000 (OLED):

  • Tab 1: Invert toggle + Factory reset — the only safe options
  • Tab 2: Invert only, with explanation of why CCT/gamma/contrast are not shown (to prevent accidentally breaking colours)

App v4.2 on Vita 2000 (LCD):

  • Tab 1: Full CCT preset list (6500K–1200K) + IPS/sRGB/Night/Boost enhancements — correct because IFTU CSC applies to pixel data
  • Tab 2: Temperature / Gamma / Contrast / Brightness / Invert sliders

Factory reset (Triangle): Calls vitabrightOledReload() to restore
the clean panel LUT from the panel-specific file on disk, then clears
invert. Restores original colours immediately without a reboot.

Installation

  1. Extract VitaBrightEX-v1.3.zip and copy all files to ur0:/tai/
  2. Add ur0:/tai/vitabright.skprx under *KERNEL in ur0:/tai/config.txt
  3. Reboot
  4. Install VitaBrightEX-LUT-Editor-v4.2.vpk via VitaShell

If ux0:/tai/ exists on your memory card it takes priority over ur0:/tai/.

Based on vitabright by devnoname120 (https://github.com/devnoname120/vitabright).
Screen filter inspired by Luma3DS Rosalina (https://github.com/LumaTeam/Luma3DS).