← Brewology.com

Vita Store › Plugins

uac-pstv v1.4 by SJK132

Released Aug 25, 2026 · Plugins

Plug a USB sound card, a USB DAC, or one of those cheap USB headphone dongles into your PSTV's USB port and system audio comes out of it: games, PSX titles, the LiveArea, everything the console plays. No app to launch and nothing to configure: attach the device and it takes over, unplug it and audio returns to HDMI on its own.
This is useful if your TV's audio is bad, if you want headphones without running a cable from the TV, or if you want a real DAC in the chain.
It is output only. Microphones and headset input are not supported.

Install on your Vita

FileSize
uac_pstv.skprx
69ef40e2…c9a9
11 KB Download

Plugin: copy uac_pstv.skprx to ur0:tai/, then add a line to ur0:tai/config.txt:

Under *KERNEL:
ur0:tai/uac_pstv.skprx

Then reboot the Vita. If your Vita has ux0:tai/config.txt, taiHEN reads that file instead. The developer's notes say if a plugin goes somewhere else.

To copy a file to ur0:tai/, use FTP in VitaShell, or copy it to ux0: over USB and move it in VitaShell (△ › Copy, open ur0:tai/, △ › Paste). Press ✕ on config.txt to edit it.

Autoplugin 2 installs many common plugins from a list on the Vita.

Homebrew needs HENkaku, h-encore, HENlo or Ensō. New to Vita homebrew? Start here.

All versions (3)

Screenshots

About uac-pstv

v1.4 - 2026-08-23

  • Fixed USB audio refusing to start after about twenty unplug/replug cycles, which until now needed a reboot to clear. SceUsbd drops a pulled device's pipe without cancelling the isochronous requests queued on it, so three are lost to its 64-entry pool every time; the plugin now hands them back after each detach.
  • Registered as a composite USB driver, claiming the audio interface rather than the whole device.
  • The firmware table now carries the SceAudio and SceUsbd module NIDs beside AVConfig's and checks all three. Every offset was re-read from the decrypted modules of all eleven supported firmware.
  • Replaced the pointer queue with one published block sequence and a two-block cursor, preserving latest-audio recovery with less shared state.
  • Fixed rapid unplug/replug by keeping teardown serialized until Sony's worker and route are clean; a replacement session remains queued until the old capture storage is safe to reuse.
  • A failed initial USB submission now fails the session instead of reporting a running stream.

Release notes

v1.4 · uac_pstv.skprx · Aug 25, 2026

v1.4 - 2026-08-23

  • Fixed USB audio refusing to start after about twenty unplug/replug cycles, which until now needed a reboot to clear. SceUsbd drops a pulled device's pipe without cancelling the isochronous requests queued on it, so three are lost to its 64-entry pool every time; the plugin now hands them back after each detach.
  • Registered as a composite USB driver, claiming the audio interface rather than the whole device.
  • The firmware table now carries the SceAudio and SceUsbd module NIDs beside AVConfig's and checks all three. Every offset was re-read from the decrypted modules of all eleven supported firmware.
  • Replaced the pointer queue with one published block sequence and a two-block cursor, preserving latest-audio recovery with less shared state.
  • Fixed rapid unplug/replug by keeping teardown serialized until Sony's worker and route are clean; a replacement session remains queued until the old capture storage is safe to reuse.
  • A failed initial USB submission now fails the session instead of reporting a running stream.

Full changelog

Something wrong with this listing? Report a problem · Are you the developer? Claim this listing